ברוכים הבאים למרכז הדפסה בתלת מימד

Premium Red ABS 1.75mm filament

זמינות: במלאי

185.00 ₪

סקירה מהירה

Premium High Temp Red 3D Printer ABS Filament 1.75mm, 0.75Kg

Premium Red ABS 1.75mm filament

לחץ פעמיים על התמונה להגדלה

הקטן
הגדל

תמונות נוספות

פרטים

Our Premium Red ABS 1.75mm filament:

Our Premium Red ABS (imported from the Netherlands) is an extra strong impact-resistant filament ideal for 3d printing of solid printed products. Due to the process
stability and physical features of Acrylonitrile Butadiene Styrene it is a widely used thermoplastic polymer in industry.
The material is also very light and durable. This makes this ABS particularly suitable for tools, toys and all kinds of
utensils. Printed at a slightly over-average temperature for ABS (2600C-2800C), this filament gives extra strong 3d print results.


.We have tested and liked the results of our premium ABS on the following 3d printers:

  • UP Plus2
  • UPrint
  • All metal extruder reprap 3d printer

Features

  • Very High Impact Resistance
  • Extra Strong
  • Stable Printing
  • Light and Durable
  • Limited warping
 

Recommendations, Tips & Tricks 

It is recommended to use a heated print bed when printing ABS. ABS has a tendency to warp, which makes it a difficult material to print without a heated print bed. Ideally your print bed temperature should be set at approximately 100°C-110°C. Please note that ABS will bend under too much heat, so after the first few layers, it’s best to turn down your print bed temperature a bit.

A good first layer adhesion is of the utmost importance in obtaining the best results for your prints. There are several tricks to get the first layer of your ABS print to stick better to the print bed of your 3D printer.

  • Use polyimide tape (Kapton tape or PET tape). ABS prints usually stick better to polyimide tape than to the print bed. When preparing the print bed it is better to have small gaps between your strokes of tape, rather than having overlaps. Overlaps of smaller pieces of tape may cause difficulties later on during the print process. 
  • Coat your print bed with hairspray. ABS has a tendency to stick really well to extra strong hairsprays.
  • Coat your print bed with ABS juice. Dissolve a little piece of ABS in 50ml of Acetone. The acetone should get slightly cloudy. To make the surface of your print bed stickier, you can lightly coat your print bed with this cloudy ABS/Acetone mixture. Please make sure not to use too much ABS in your juice as it will make your prints stick too well and be extremely difficult to remove.

PET tape and Kapton tape are unlikely to leave a residue on your print bed. Hairspray and ABS/Acetone juice coatings will leave a residue on your print bed.

היה ראשון לתת חוות דעת על מוצר זה

תגיות המוצר

השתמש ברווחים על מנת להפריד בין התגיות. השתמש בגרשיים בודדות (') לביטוים.